Tuesday, March 30, 2021

Warmaster: City and Graveyard

I'm calling this project complete. I think my family thought I'd gone a little mad with this one (well ... more so than usual).

It's a modular 3d printed Warmaster city (i.e. 10mm scale), complete with graveyard and city walls. I don't even own an army yet that would call this thing home ... although the Skaven would probably like invading it. So at some point I should probably get a Empire or Bretonnian army (or Vampire Counts).

The pictures show one possible layout. There's not enough walkways for all of the walls, but there are enough for 6+ Warmaster infantry units worth, which seemed like plenty for a reasonable army. Not everything is pictured here (there were a number of bits I didn't setup in this photoshoot ... mostly extra ruins, barrels, and fieldstone walls). I could also set this up on one side of a table to imply a much larger city off screen.

Only the graveyard pieces were painted this month.
  • 17 Gravestone Bases
  • 3 Small Mausoleums
  • 2 Large Mausoleums
I ran my 3d printer until it finally broke down. So that makes me sad. I was trying to print rivers and bridges to add to the city. I'm still trying to troubleshoot it, but this seems like a bad break. It's not heating either the print bed or the filament and the reason isn't obvious, the fact that 2 parts seem to have broken at the same time suggest to me it might be software related (although it happened when I was trying to print a river piece that had a particularly bad scaling down attempt).

Now onto the pictures:





 

No comments:

Post a Comment